IMPORTANT: This procedure will overwrite all data on the panel PCs disk. If you have any data on the panel PC that you wish to keep, please back it up before continuing with this procedure.
For this procedure, the touch screen will not work until the necessary is software is installed. Therefore, it may be necessary to connect a keyboard and mouse to the panel PC in order to perform the installation.
wget https://www.eeti.com/touch_driver/Linux/20210716/eGTouch_v2.5.10206.L-x.tar.gz tar -xf eGTouch_v2.5.10206.L-x.tar.gz sudo mkdir -p /opt/EETI/ sudo mv eGTouch_v2.5.10206.L-x /opt/EETI/eGTouch rm -rf eGTouch_v2.5.10206.L-x.tar.gz
cd /opt/EETI/eGTouch
followed by sudo ./setup.sh
to install the software to make the touchscreen workY
to accept the license agreement2
to select the USB interfaceENTER
when prompted to do soN
to the multi-monitor questionY
to add the usbtouchscreen kernel module to the blacklist1
for the controller count questionsudo /opt/EETI/eGTouch/eGTouch64/eGTouch64withX/eGTouchU
to open the touch controller's settings application.Ubuntu is now ready for use.