The CP-IO19R is an IO relay board accessory for the ComfilePi A & B Series Panel PCs (CPi-A & CPi-B) consisting of 11 inputs, 8 relay outputs, screw terminals, and corresponding indicator LEDs. It can be mounted to the rear panel of the ComfilePi.
The following is an example project illustrating how to program the CP-IO19R in C# using the Mono Framework.
.NET 6 drivers can be found at the .NET IoT Libraries API Reference.
The pigpio library also has a Python interface.
The following is an example illustrating digital inputs and outputs:
import pigpio pi = pigpio.pi() pi.set_mode(4, pigpio.INPUT) pi.set_mode(17, pigpio.OUTPUT) while True: if pi.read(4): pi.write(17, 1) else: pi.write(17, 0) pi.stop()
The CP-IO19R's pins are connected to the ComfilePi's GPIO header as shown below.
Inputs: GPIO 4, 5, 6, 7, 8, 9, 10, 11, 12, 13, 16
Outputs: GPIO 17, 18, 19, 20, 21, 22, 23, 24
It may be necessary to modify the ComfilePi's initial GPIO output state to prevent the ComfilePi from turning the outputs ON when the ComfilePi boots.
Modify the ComfilePi's /boot/config.txt file with the following configuration to set the initial IO state. See GPIO control in config.txt for more information.
gpio=4-13=ip gpio=16=ip gpio=17-24=op,np,dl