|port||I/O port number (0 to 255)|
Set the port's I/O mode to output. All Cubloc module's I/O ports are set to High-Z input by default at power on.
Output 8 'Set port 8's I/O mode to output.
You can also use the High or Low commands to set a port's I/O mode to output. When using the Output command, the port's output (logic high or logic low) is not clearly defined. Therefore, it recommended to use the High or Low commands to set a port's I/O mode so the port's output is properly initialized.
Low 8 'Set port 8's I/O mode to output and output a logic low.
For the CB290 and the CT1721, you must use Set Outonly On to use P24 ~ P55 as outputs.