Set Spi clk, mosi, miso, mode
|clk||port for clock output|
|mosi||port for data (Master output, Slave Input)|
|miso||port for data (Master input, Slave output)|
|bit 3: 0 = MSB start, 1 = LSB start|
|bit 2: 0 = wait at clock LOW, 1 = wait at clock HIGH|
|bit 1: Output sample point; 0 = before rising edge, 1 = after rising edge|
|bit 0: Input sample point; 0 = before rising edge, 1 = after rising edge|
Set Spi command must be used prior to the Spi command to ensure
the I/O ports are defined prior to sending or receiving data.
Const Device = CB280 Dim Dtin As Byte Set Spi 9,8,7,0 Dtin = Spi(Dtout,32)
For a more complete example, see the file C:\Program Files (x86)\ComfileTools\CublocStudio\CM100A in CUBLOC Studio's installation folder.