modport:md-adin4:index
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
modport:md-adin4:index [2023/04/28 22:23] COMFILE Technology [Modbus Starting Address] |
modport:md-adin4:index [2023/05/31 04:34] (current) COMFILE Technology [4-Channel Analog to Digital Input Module: MD-ADIN4] |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| - | ====== MD-ADIN4 ( AD Input Module ) ====== | + | ====== 4-Channel Analog to Digital Input Module: MD-ADIN4 ====== |
| - | ^Output Value ^Resolution ^Precision ^Conversion Speed^ | ||
| - | |0 ~ 10,000 |13.30bit| ±0.1% |30ms per channel| | ||
| The AD Input Modules can be wired to read voltage sources or current sources. | The AD Input Modules can be wired to read voltage sources or current sources. | ||
| - | {{ :modport:md-adin4:md-adin4.png?700 |}} | + | {{ :modport:md-adin4:md-adin4.png?600 |}} |
| When reading voltages sources, the modules can be configured for a 0 ~ 10V range or a 1 ~ 5V range using the dipswitch on the side of the module. | When reading voltages sources, the modules can be configured for a 0 ~ 10V range or a 1 ~ 5V range using the dipswitch on the side of the module. | ||
| Line 15: | Line 13: | ||
| {{ :modport:md-adin4:dipswitch.png?nolink |}} | {{ :modport:md-adin4:dipswitch.png?nolink |}} | ||
| - | |||
| - | |||
| ===== Specification ===== | ===== Specification ===== | ||
| ^ Item ^ Description ^ | ^ Item ^ Description ^ | ||
| + | | Channels | 4 | | ||
| | Operating Temperature | -10 ~ 50 (no condensation) | | | Operating Temperature | -10 ~ 50 (no condensation) | | ||
| | Operating Humidity | 35 ~ 85%RH | | | Operating Humidity | 35 ~ 85%RH | | ||
| Line 31: | Line 28: | ||
| | Packet Transmission | 3ms | | | Packet Transmission | 3ms | | ||
| | Isolation Method | No Isolation | | | Isolation Method | No Isolation | | ||
| + | |||
| + | |||
| + | |||
| **Important**: The AD Input Modules' inputs are not isolated, so please be sure to not provide voltage or current in excess of the specified ranges. Doing so could cause permanent damage. | **Important**: The AD Input Modules' inputs are not isolated, so please be sure to not provide voltage or current in excess of the specified ranges. Doing so could cause permanent damage. | ||
| Line 76: | Line 76: | ||
| Rotary switch position 0 corresponds to Modbus slave address 10. If the ID is changed after the module is powered on, it must be power cycled for the new ID to take effect. | Rotary switch position 0 corresponds to Modbus slave address 10. If the ID is changed after the module is powered on, it must be power cycled for the new ID to take effect. | ||
| + | |||
| + | [[modport:index|MODPORT]] | ||
modport/md-adin4/index.1682688213.txt.gz · Last modified: 2023/04/28 22:23 by COMFILE Technology