modport:md-daout2:index
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
modport:md-daout2:index [2023/04/29 12:53] COMFILE Technology [Table] |
modport:md-daout2:index [2023/05/31 04:35] (current) COMFILE Technology [2-Channel Digital to Analog Voltage Output Module: MD-DAOUT2] |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| - | ====== MD-DAOUT2 - 2 Channel Digital to Analog Voltage Output Module ====== | + | ====== 2-Channel Digital to Analog Voltage Output Module: MD-DAOUT2 ====== |
| The MD-DAOUT2 is a 2-channel digital to analog voltage, 0~5V / 0~10V, output module. | The MD-DAOUT2 is a 2-channel digital to analog voltage, 0~5V / 0~10V, output module. | ||
| The voltage range is configured using the dipswitch on the side of the module. | The voltage range is configured using the dipswitch on the side of the module. | ||
| - | {{ :modport:md-daout2:md-daout2.png?700 }} | + | {{ :modport:md-daout2:md-daout2.png?550 }} |
| ===== Specification ===== | ===== Specification ===== | ||
| ^ Item ^ Description ^ | ^ Item ^ Description ^ | ||
| + | | Channels | 2 | | ||
| | Operating Temperature | -10 ~ 50℃ (no condensation) | | | Operating Temperature | -10 ~ 50℃ (no condensation) | | ||
| | Operating Humidity | 35 ~ 85%RH | | | Operating Humidity | 35 ~ 85%RH | | ||
| Line 17: | Line 18: | ||
| | Maximum Conversion Rate | 0 ~ 60,000, 600ms | | | Maximum Conversion Rate | 0 ~ 60,000, 600ms | | ||
| | Isolation Method | No Isolation | | | Isolation Method | No Isolation | | ||
| + | |||
| + | ===== Output Voltage ===== | ||
| + | |||
| + | Values between 0 ~ 60,000 correspond linearly to the output voltage (0 ~ 10V, dipswitch OFF / 0 ~ 5V, | ||
| + | dipswitch ON). | ||
| + | |||
| + | {{ :modport:md-daout2:daout_chart.png }} | ||
| Line 33: | Line 41: | ||
| Rotary switch position 0 corresponds to Modbus slave address 10. If the ID is changed after the module is powered on, it must be power cycled for the new ID to take effect. | Rotary switch position 0 corresponds to Modbus slave address 10. If the ID is changed after the module is powered on, it must be power cycled for the new ID to take effect. | ||
| + | |||
| + | [[modport:index|MODPORT]] | ||
modport/md-daout2/index.1682740381.txt.gz · Last modified: 2023/04/29 12:53 by COMFILE Technology