This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Last revision Both sides next revision | ||
cuwin:setting_the_cuwin_s_operating_mode_dip_s_w_setting:index [2022/08/24 14:40] COMFILE Technology [AutoRun Mode] |
cuwin:setting_the_cuwin_s_operating_mode_dip_s_w_setting:index [2024/01/29 09:44] COMFILE Technology [AutoRun Mode] |
||
---|---|---|---|
Line 1: | Line 1: | ||
+ | ====== Setting the CUWIN's Operating Mode ====== | ||
+ | The CUWIN is very flexible and can operate in many modes depending on the CUWIN's final purpose. | ||
+ | The following table lists the CUWIN's different operating modes. | ||
+ | |||
+ | {{ :cuwin:setting_the_cuwin_s_operating_mode_dip_s_w_setting:cuwin_dipsw.png?nolink |}} | ||
+ | |||
+ | {{ :cuwin:setting_the_cuwin_s_operating_mode_dip_s_w_setting:cuwin_dipsw_table.png?nolink |}} | ||
+ | |||
+ | ===== Development Mode ===== | ||
+ | |||
+ | Development mode boots the device to the operating system's desktop which is the typical environment for software development. | ||
+ | |||
+ | ^ CUWIN Model ^ DIP Switch Configuration ^ | ||
+ | | 5000/6000/CWA Series | 1-On, the rest Off | | ||
+ | | CWV / CWV2 Series | All Off | | ||
+ | |||
+ | ===== AutoRun Mode ===== | ||
+ | To configure the CUWIN to automatically run a program when the system boots, create the folder “\Flash | ||
+ | Disk\AutoRun” (or "\Storage Card\AutoRun" for the SD card) and copy the *.exe file to execute into that folder. Then configure the device for AutoRun mode. | ||
+ | |||
+ | ^ CUWIN Model ^ DIP Switch Configuration ^ | ||
+ | | 5000/6000/CWA Series | 1-On, 2-On, the rest Off | | ||
+ | | CWV / CWV2 Series | 2-On, the rest Off | | ||
+ | | CWR | Use the dedicated "AUTO RUN" switch on the back of the device next to the COM3 port | | ||
+ | |||
+ | [[cuwin:index|CUWIN - Windows CE Industrial Touchscreen Panel PC]] |