Differences

This shows you the differences between two versions of the page.

--- modport:modport_module_starting_address_and_rtu_function_codes:index [2023/04/27 20:28]
COMFILE Technology
+++ modport:modport_module_starting_address_and_rtu_function_codes:index [2023/05/31 04:27] (current)
COMFILE Technology [Module ID (Modbus Slave Address) Assignment]
@@ Line 1: / Line 1: @@
 ====== Module Slave Address, Starting Address, and Function Codes ======
-===== Module ID (Modbus Slave Address) Assignment =====
-On the front of the module, there is a rotary switch labeled //ID//, that is used to select the Modbus slave address for the module. When installing multiple modules of the same type, the ID for each module should be unique.
-Rotary switch position 0 corresponds to Modbus slave address 10. If the ID is changed after the module is powered on, it must be power cycled for the new ID to take effect.
 All values below are given in base 10.
@@ Line 32: / Line 26: @@
   * MODBUS RTU protocol
   * Broadcast mode not supported
+===== Module ID (Modbus Slave Address) Assignment =====
+http://www.comfilewiki.co.kr/en/lib/images/toolbar/image.png
+On the front of the module, there is a rotary switch labeled //ID//, that is used to select the Modbus slave address for the module. When installing multiple modules of the same type, the ID for each module should be unique.
+Rotary switch position 0 corresponds to Modbus slave address 10. If the ID is changed after the module is powered on, it must be power cycled for the new ID to take effect.
+[[modport:index|MODPORT]]

User Tools

Site Tools

Differences

Page Tools