modport:modport_module_starting_address_and_rtu_function_codes:index
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
modport:modport_module_starting_address_and_rtu_function_codes:index [2023/04/27 20:29] COMFILE Technology |
modport:modport_module_starting_address_and_rtu_function_codes:index [2023/05/31 04:27] (current) COMFILE Technology [Module ID (Modbus Slave Address) Assignment] |
||
|---|---|---|---|
| Line 27: | Line 27: | ||
| * Broadcast mode not supported | * Broadcast mode not supported | ||
| - | ==== Module ID (Slave Address) ==== | + | ===== Module ID (Modbus Slave Address) Assignment ===== |
| - | + | http://www.comfilewiki.co.kr/en/lib/images/toolbar/image.png | |
| On the front of the module, there is a rotary switch labeled //ID//, that is used to select the Modbus slave address for the module. When installing multiple modules of the same type, the ID for each module should be unique. | On the front of the module, there is a rotary switch labeled //ID//, that is used to select the Modbus slave address for the module. When installing multiple modules of the same type, the ID for each module should be unique. | ||
| Rotary switch position 0 corresponds to Modbus slave address 10. If the ID is changed after the module is powered on, it must be power cycled for the new ID to take effect. | Rotary switch position 0 corresponds to Modbus slave address 10. If the ID is changed after the module is powered on, it must be power cycled for the new ID to take effect. | ||
| + | |||
| + | [[modport:index|MODPORT]] | ||
modport/modport_module_starting_address_and_rtu_function_codes/index.1682594976.txt.gz · Last modified: 2023/04/27 20:29 by COMFILE Technology